ESP RainMaker Examples

While building any examples for ESP RainMaker, take care of the following:

1. Change the partition scheme that fits your flash size in Arduino IDE to RainMaker 4MB, RainMaker 4MB no OTA or RainMaker 8MB (Tools -> Partition Scheme -> RainMaker).
2. Once ESP RainMaker gets started, compulsorily call WiFi.beginProvision() which is responsible for user-node mapping.
3. Use the appropriate provisioning scheme as per the board.
   • ESP32 Board: BLE Provisioning
   • ESP32-C3 Board: BLE Provisioning
   • ESP32-S3 Board: BLE Provisioning
   • ESP32-S2 Board: SoftAP Provisioning
   • ESP32-C6 Board: BLE Provisioning
   • ESP32-H2 Board: BLE Provisioning
4. Set debug level to Info (Tools -> Core Debug Level -> Info). This is the recommended debug level but not mandatory to run RainMaker.